I have this somewhat custom linkage set up on my 273 in my 66 Barracuda. The way it's currently set up, I'm not getting full throttle out of my Edelbrock carb. I'm barely getting half throttle. The travel between the pedal and the floor is very short. I canted the throttle cable bracket further back, towards the firewall. I did get full throttle, but the pedal stuck out at an extremely awkward angle. As you can tell from the picture, the way the cable archs up makes it seem like it might be...
Current linkage not allowing for full throttle
Current linkage not allowing for full throttle
The post Current linkage not allowing for full throttle appeared first on Classic Mopar Forums.