Rainy day $25 and under sale interior stuff
More cheap stuff from organizing. Thanks as always for the interest. Early cuda door emblems( each one missing an attaching clip)-$25 plus shipping. 65 radio bezel( needs paint or rechrome but no...
View ArticleLD340, 340HP mani, roller rockers
I've got a very nice unmodified LD340 with the Chrysler part number. $300 plus shipping Next is a pair of 340 exhaust manifolds. The drivers side is a later casting, but still has the 2.25" outlet. The...
View ArticleTwin Turbo LiL Red Express
I started a build a couple years ago with an all Original Lil Red Express. I have owned the truck for 15 years. I know its not an A-Body but this turbo forum has been very helpful in the direction I am...
View ArticleEFI and Ignition
Whelp, as most of you know my carb (among other things) were stolen last week. Even before that I had been kicking around the idea of going with EFI so now its kind of obvious to go the EFI route. At...
View ArticleSpark plug advice
Im in the process of finishing my 340 build and would like to close off all engine openings to avoid dust or critters from entering my motor. I need spark plug selection advice. My motor is a .040 over...
View ArticleW2 / W5 Rocker Shafts
I have a set of W2 race heads I've had for years. With family priorities and limited funds through the years, I bought parts for my small block stroker recipe as I was able. I have 2 sets of...
View ArticleElectric Fuel Pump Mounting
Just looking for ideas for mounting an electric fuel pump on the rear frame rail. Can you folks post pictures of how you did it? Did you guys use some sort of rubber isolator mounts? The post Electric...
View ArticleOil light stays on too long on a cold start
My 81-87 225 has an issue with the oil light staying on too long when you first start it, around the same length of time you see after an oil change. This engine is very sound, it's a rebuild from a...
View Article7.25 rear internals
Will the internals from a 63 Dodge Dart 7.25 work in a 7.25 in a 73 Dodge Dart ? The post 7.25 rear internals appeared first on Classic Mopar Forums.
View ArticleBest way to remove rust preventative coating?
My new Spectra gas tank came with a rust preventative coating. It's not waxy like cosmoline, more oily like LPS3. Whats the best way to remove this stuff without causing problems to the gas tank? For...
View ArticleRemove heater blower system.
Hi, Looking to remove the heater blower everything system out of my 69 Dart. How hard it is to do or can it be done without pulling the Dash? no AC Thanks The post Remove heater blower system. appeared...
View ArticleLD340 and 915 “O” heads
LD340 intake. Good shape. Was painted blue when I got it, had it stripped and blasted but there's still a couple small areas of residual blue. Asking $300/shipped to the lower 48 for the intake. Small...
View ArticleOrange Dragstrip Reunion&Carshow MA
Orange Dragstrip Reunion and carshow. Home of the 330' drag nationals. It's a great time. Located in Sterling MASS. PRE 74 CARS ONLY. View attachment 1715054400 The post Orange Dragstrip...
View ArticleEddy 1406 Questions
Trying to remove the lean bog from my car I wanted to look at how the butterflies looked and were the T-port was set. So I pulled the carb and noticed that I have an exceptional amount of T-port...
View ArticleClik here to view.
Pure stock drags
stumbled upon this website and was checking out the "pure stock" drag times with very limited upgrades allowed to the stock cars. Nice showing for 2 340 Dusters in an otherwise big block dominated...
View Articlelong to short tailshaft swap question
Well now that my son and I finally got his 70 Duster project on the road, we are very unhappy with the a833od we put together, basically we built one out of two we had using original parts and...
View Article1965 Valiant radio wiring harness question
So my 65 Valiant does not have a radio. However, the fuse box has a fuse in the radio slot and is live in the on and acc positions. Before I try to get under the dash and get my bifocals to focus, was...
View ArticleWhats your thoughts on this glove box door
I was fortunate enough to get my glove box signed last year by Richard Petty and then 2 weeks later Don Garlits was in the area and I got his autograph as well on the door. View attachment 1715054395...
View ArticleNew 440 Edelbrock Sixpac Manifold
I am selling my brand new 440 Six-Pac Edelbrock never been put on a motor still in original box for 425.00 plus the ride from WA. state. Thanks for looking... View attachment 1715054429 View...
View Article68 Dodge Dart tail lights (set)
I am sell a nice set of 68 Dart Tail lights, lens are in very nice shape with no cracks, there is minor pitting on the inside part of the housing as showed in one of the pics. These are in pretty good...
View Article